curing for use with Hardener yellow possible!
Hardener yellow is used, the curing process
can be accelerated by heat addition. For this purpose the metallic
substrate and not the PolymerMetal must be
up after application. A temperature of 70 °C
over a period of one hour is enough for remarkable good
technical data of dimensionally stable layer thicknesses up
to 10 mm. The metal temperature should not exceed a
maximum of 120 °C. The quick curing procedure can even
be carried out at ambient temperatures below 0 °C.
mentioned information has already been embedded in the latest
versions of the concerned technical data sheets which will be
sent to you upon request immediately.
Technical Data Sheets
MultiMetall® • PolymerMetall® • Ceramium® • Molymetall® • Sealium® • XETEX® • the